03423220016
Sosyal Medya Hesaplarımız

Biosystems Calibrator Proteins Reagent

Biosystems Calibrator Proteins Reagent

 

The set of the Calibrator of proteins consists of five liquid human serums containing proteins in the concentration convenient for creation of a calibration curve necessary when determining the proteins given below.

 

 

STRUCTURE

The calibrator level 1 – 1 ml

The calibrator level 2 – 1 ml

The calibrator level 3 – 1 ml

The calibrator level 4 – 1 ml

The calibrator level 5 – 1 ml

Components of a human origin were checked for lack of antibodies to HIV and HCV, as well as to Hbs – an anti-gene. However, it is necessary to show care during the work with this serum as a potential source of infections.

 

Biosystems Calibrator Proteins Reagent  INTENDED USE

The Protein Calibrators are intended for quality control purposes only and is supplied with suggested intervals of acceptable values.

COMPOSITION

Protein Calibrators. Liquid human sera containing several proteins at concentrations suitable for the calibration of measurement procedures.
Components from human origin have been tested and found to be negative for the presence of antibodies anti-HIV and anti-HCV, as well as
for HBs antigen.

However, they should be handled cautiously as potentially infectious.

PREPARATION AND USE

The Protein Calibrators are provided ready to use. Before opening, allow the vial to reach room temperature and then mix carefully avoiding the formation of foam.
Analyze the Protein Calibrators in the same way as the patient samples.

STORAGE AND STABILITY

Store at 2-8ºC.
Protein Calibrators are stable until the expiration date given in the label if stored tightly closed and contamination during use is avoided.

SPECIFIED VALUES

The assigned concentration values for components and their traceability are shown in the enclosed value sheets.

Traceability of the results can be assured only if the BioSystems reagents and recommended measurement procedures are used.
The suggested intervals of acceptable values have been calculated from previous experience in interlaboratory variability and are given for
orientation only.

Each laboratory should establish its own precision parameters.

 

Brand: Biosystems